728*90 Advertising Space
Home Depot Ratings and Reviews
Home>

Customer reviews for Canyon Yew 32 sq. ft. MDF Wall Panel

Canyon Yew 32 sq. ft. MDF Wall Panel

The Canyon Yew 32 sq. ft. MDF Wall Panel is made of medium-density fiberboard and pre-finished. It is not recommended for ceilings. It offers the traditional appearance of natural wood paneling.
Overall rating:
2.75 / 5
2.8
 / 
5
(4 reviews) 4
Open Ratings Snapshot
50%of customersrecommend this product2 of 4reviews
Rating Breakdown 4 reviews
2.8 out of 5.0
5
(0)
4
(2)
3
(0)
2
(1)
1
(1)
Quality 
2.5 out of 5.0
2.5 out of 5
Value 
2.8 out of 5.0
2.8 out of 5
50%of customersrecommend this product2 of 4reviews
Customer reviews for Canyon Yew 32 sq. ft. MDF Wall Panel
Review 1 for Canyon Yew 32 sq. ft. MDF Wall Panel
from Vermont
Age Range:35 to 44
,
Gender:Male
Home Improvement Profile:DIYer

Looks Great

PostedMarch 20, 2012
Overall rating 
4.0 out of 5.0
4 out of 5
Quality 
4.0 out of 5.0
4 out of 5
Value 
4.0 out of 5.0
4 out of 5
I had to replace a ceiling that is sloped from 13'4" to 9'4" and really didn't want to use sheetrock again so even though this paneling isn't recommended for ceilings I went with it. I put 5/8" OSB under it and glued it with Liquid Nails Paneling Glue and nailed it with brown stainless steel nails because the cheaper paneling nails usually bend. I ran the paneling sideways so the "planks" look like actual 8" knotty boards going across the ceiling and by staggering the joints I had 2 rows of joints where the 4' ends met so I stained 2- 2x6's to look like beams and ran them up the ceiling. It's been 3 weeks now and the paneling still looks as good as the day I put it up, it hasn't sagged anywhere and the joints are all still tight, I would recommend putting a backerboard under paneling and glue even if you're putting it on a wall.
+22points
22out of 22found this review helpful.
Review 2 for Canyon Yew 32 sq. ft. MDF Wall Panel

Very Pleased

PostedDecember 27, 2012
Overall rating 
4.0 out of 5.0
4 out of 5
Quality 
3.0 out of 5.0
3 out of 5
Value 
5.0 out of 5.0
5 out of 5
Installed in a secondary bathroom over painted drywall with Liquid Nails adhesive from top to botoom and in the middle along with brad nails at the edges. No sagging, bulging, warping or any negative issues. Just don't use in a high traffic area as suraface layer is thin and could tear easily. And hand pick each sheet as quality from sheet to sheet varies.
Pros: Easy to Install, Economical
+18points
18out of 18found this review helpful.
Review 3 for Canyon Yew 32 sq. ft. MDF Wall Panel
from Mississippi, USA

Looks good, poor quality

PostedJune 11, 2012
Overall rating 
1.0 out of 5.0
1 out of 5
Quality 
1.0 out of 5.0
1 out of 5
Value 
1.0 out of 5.0
1 out of 5
No, I do not recommend this product.
I put this up on the wall of a house I was remodeling. I used finishing nails to nail it to the wall. When i returned one week later, the wall had bowed and buckled and was not even remotely smooth. I am not sure what caused this, my guess is humidity or heat because the a/c was turned off in the house. Regardless what caused this, it is unacceptable, and if it was caused by change in temp., a product should be able to withstand temp. change of +-15 degrees. I had to take all of the wall board down and return it.
+6points
17out of 28found this review helpful.
Review 4 for Canyon Yew 32 sq. ft. MDF Wall Panel

Not Impressed

PostedJanuary 12, 2012
Overall rating 
2.0 out of 5.0
2 out of 5
Quality 
2.0 out of 5.0
2 out of 5
Value 
1.0 out of 5.0
1 out of 5
No, I do not recommend this product.
bought these panels cause of the reviews i read at other stores,,, they said let set in the room for 3 or more days before installing.... i let set over a week, after have over half of them nailed up ---- most show buckling from top to bottom..... i should have gone with my first idea --- 1/4inch smooth sided flywood... or Luan paneling
.....
+9points
19out of 29found this review helpful.