September 23, 2015
The tub does not come with a drain kit, so you will be required to purchase it separately. You can find it here: http://www.homedepot.com/p/American-Standard-Deep-Soak-Drain-1599-500-020/100677630
Internet #100677630 Store SKU # 553243
The specifications mention that the heater is optional, however, every review I've read about this product has mentioned that the purchaser also bought the heater and was very glad they did. Everyone has highly recommended getting the heater. That's what I did as well, and like the others, I'm glad I did that. I can take a long soak in this jetted tub, and the water stays the perfect temperature. There's a removable section of pipe that comes with the tub, and is held in place with some large compression fittings. You simply remove that section and replace it with the heater. On my tub, one of the compression fittings on the removable section was cracked, causing the tub to leak. By replacing it with the heater (which I was going to put in anyway), the problem was solved, because the heater has it's own compression fittings.
The heater can be found here:
Internet # 100057101
This tub will require TWO dedicated 15amp circuits, each with a GFCI circuit breaker. (One for the pump motor, and one for the heater) These special breakers would usually be installed in your circuit breaker panel. This means running two lines from the breaker panel to the tub. It might mean crawling through your attic or basement. Definitely hire this out to a qualified electrician if you have no electrical wiring experience. Remember, you're dealing with electricity near water, and for obvious reasons the electrical must be done right, and must be in compliance with code.
While the tub does have a removable panel in the front, it really doesn't provide enough room to access everything. It provides decent access to where the heater is, but does not provide very good access to the pump. For that reason, you will need to create an access area on wall where the foot of the tub (where the pump is located, the wall opposite the water valve) is. This would be a square or rectangular opening you would create in the wall during the framing process. The opening would need to be approximately 2 feet by 2 feet, and would be accessed from the room on the other side of this wall. If I'm not mistaken, this access area is a requirement for home warranty service, otherwise, if they needed to replace the pump, they'd probably have to cut a hole in the wall to get to it, because it can't be easily accessed from the front apron panel.
As for the actual installation of the tub, I'm sure there are plumbing companies who could install it for you if you don't feel qualified to do it. If you decide to hire it out, make sure whomever does it is licensed and certified. Check their references.
If you wish to tackle the installation yourself, there are many tutorials on Youtube which show you how to install a tub.
I installed mine myself. The hardest part for me was getting the old tub out of there. It was a cast iron tub which weighed over 500 pounds. Yikes! We had to smash it into pieces with a sledge hammer to get it out of there. Very messy (and loud!) process. The actual install process for the new tub wasn't too bad. Setting the tub in mortar was a bit challenging. It involved dumping several large dollops of mortar on the floor where the tub would go, and then setting the tub in place on top of it, pressing down so that the tub was sitting in the mortar. I wouldn't say this was extremely difficult, but it is a bit of a messy job, and buckets of mortar aren't exactly lightweight. Everything else about the installation was fairly simple, I thought. Hope this helps.
7out of 7found this answer helpful.