AbeFM
 
 
 
AbeFM's stats
 
  • Review count
    1
  • Helpfulness votes
    5
  • First review
    April 30, 2011
  • Last review
    April 30, 2011
  • Featured reviews
    0
  • Average rating
    2
 
Questions
  • Question count
    0
  • Helpfulness votes
    0
  • First question
    None
  • Last question
    None
  • Featured questions
    0
 
Answers
  • Answer count
    0
  • Helpfulness votes
    0
  • First answer
    None
  • Last answer
    None
  • Featured answers
    0
  • Best answers
    0
 
 
AbeFM's Reviews
 
The Swan Corporation 25 in. x 22 in. Polypropylene Laundry Tub is an economical yet sturdy basin that will meet your household laundry and utility needs for years. Its 22-gallon basin sits atop 4 angular steel legs and is stain resistant. Install the faucet set of your choosing in its 3 faucet holes. In addition to the leg set, this laundry tub comes with a molded-in drain, stopper and complete installation instructions.
 
Overall ratingĀ 
2 / 5
2 / 5
Looks nice, Hard to Install, Bad Drain,
PostedApril 30, 2011
Customer avatar
AbeFM
fromĀ San Diego, CA
Sink looked great, no sharp edges like previous sink - a godsend, people have been cut so bad on previous sink they needed stitches!
Anyway, there are two big problems:
1) The sink wouldn't drain! The drain is not in the center like my previous sink - so water has to make it to the back, and with a flat bottom it just pools everywhere.
2) When trying to tilt it back, the sink kept wanting to stay level, even when adjusting the feet. Eventually I removed the back legs and put a 2x4 on the wall and had to forcibly bolt the rear of the sink down.
I bought this because of free shipping, and like the quality of the construction - but it's lacking in engineering. Pass on this one.
No, I do not recommend this product.
+3points
5out of 7found this review helpful.
 
AbeFM's Questions
 
AbeFM has not submitted any questions.
 
AbeFM's Answers
 
AbeFM has not submitted any answers.